- Sized for .156" (3.96mm) nipples
-
FIts the following size spoke nipples:
- .127" (3.23mm)
- .130" (3.30mm)
- .136" (3.45mm)
-
- 3.2mm square drive, with a nominal outside shaft diameter of 6mm
- 5mm hex socket with a nominal outside shaft diameter of 7.5mm
- 5.5mm hex socket with a nominal outside shaft diameter of 8mm
- Slips perfectly into the tight surroundings of most rims
- Works with wheels made by numerous manufacturers including, but not limited to:
- FSA
- Blackwell
- Planet-X
- HED
- Rolf
- Bontrager
- Campagnolo
- Mavic
-
- Smaller end fits 6-spline nipples with a 5.5mm outside spline diameter and 7mm thread size nipple
- Commonly found on R-sys wheels
- Equal to the sizing of the Mavic® M40652 wrench
- Larger end fits 6-spline 9mm FORE drilled rim adapters
- Commonly found on rims such as Mavic® XM819, EX823 and Speedcity wheels
- Equal to the sizing of the Mavic® M40630 or M40494 spoke wrench
- Smaller end fits 6-spline nipples with a 5.5mm outside spline diameter and 7mm thread size nipple
-
- Smaller end fits 7-spline nipples with a 6.4mm outside spline diameter
- Commonly found on R-sys wheels
- Larger end fits 6-spline 9mm FORE drilled rim adapters
- Commonly found on rims such as Mavic® XM819, EX823 and Speedcity wheels
- Equal to the sizing of the Mavic® 108 471 01 wrench
- Smaller end fits 7-spline nipples with a 6.4mm outside spline diameter
-
- Sized for 0.136" (3.45mm) nipples
- Same size as the SW-2 (red)
-
- Quick and easy access to hold virtually any wheel to perfectly position your work for a variety of tasks including but not limited to:
- Wheel building
- Cassette removal and installation
- Tire and tube removal and installation
- Tubeless tire work
- General cleaning
- Hub work
- Holds wheel at vertical, 35 degrees from vertical, and horizontal positions
- Accepts 12, 15, and 20mm thru axles and 5mm skewers
- E-Nickel finish for durability
- Quick and easy access to hold virtually any wheel to perfectly position your work for a variety of tasks including but not limited to:
